SPA tips

2 speed spa pump troubleshooting

Why does my hot tub have 2 pumps?

Some hot tubs have single-speed pumps, but in those cases, there are two pumps. One is called the circulation pump, which runs at a much lower speed and uses less energy than any other pumps. … The second pump would function at a higher speed to power the jets in your tub. These can be single or variable speed.

Why is my spa pump not working?

When your hot tub pump is dead…

Check that your power is on, the breaker or GFCI test button are not tripped, all valves are in the open position. Follow the circ pump plumbing, and look for any kinks in the hose. Pull out the cartridge filter to see if flow improves and the circulation pump is doing better.

How do I reset my hot tub pump?

How to Reset a Spa Heater

  1. Locate the spa’s high-limit reset. This is a red button found on many spa packs. …
  2. Press the high-limit reset button. …
  3. Turn on your spa and observe its operation. …
  4. Flip the breaker panel switch on or press the reset button on the GFCI outlet to restore power.

How long do spa pumps last?

5 to 10 years

How long should a spa pump run per day?

eight hours per day

How do I know if my hot tub pump is bad?

Symptoms of Spa Pump Failure

There are several signs of hot tub pump failure: Humming noise from motor not turning, frozen shaft, bearings or impeller, or defective starting capacitor. Whining noise from worn bearings. Leaks under the pump from a failure of the pump seals.

You might be interested:  Steam room spa near me

Is there a reset button on a hot tub pump?

To reset a hot tub heater you need to locate the red reset button which will probably be on the heater in the service bay of the hot tub. All you need to do is to press it to reset it and everything should be good to go.

How much does it cost to replace a spa pump?

If you decide your hot tub pump is having problems, you should budget about $200 to $500 for repairs. There are a few common signs the pump is having issues, including: No water coming out of the jets.

How do I test my hot tub control panel?

Turn the power on and check if the hot tub heats up or starts to filter. The surest way to check if a control panel works is to use one you know is working and connect it to the circuit board.

How do you unblock a spa jet?

The first thing you want to do is:

  1. Turn your system back on, but turn the heat down to as low as it will go. This step will keep the heater from kicking on during this process.
  2. Next, go around your hot tub and make sure all of the jets are completely open.

What does code SL mean on hot tub?

If the SLP or SL Message is ON Solid (Not Flashing) on the Display, the Spa is Operating in the Sleep Heating Mode, but there is No current water temperature because the Spa is between Filter Cycles. … The Water Temperature will probably drop Below Set Temperature between Filter Cycles.

You might be interested:  Elizabeth arden red door spa nyc

Is it worth repairing a hot tub?

A well made hot tub should last around 10-15 years. If your hot tub is only 5 or 6 years old, it almost always makes sense to repair it as you should have at least another 5 years life out of it. On the other hand if your hot tub 15 or more years old it is likely living on borrowed time and should probably be replaced.

Should I turn my hot tub down when not in use?

The general rule of thumb for temperature is that when not in use, the temperature should be set to about 5 degrees lower than when in use. Depending on the climate, this is necessary to keep the water warm enough to reach operating temperature quickly and without wasting energy when the time comes.

Leave a Reply

Your email address will not be published. Required fields are marked *