SPA tips

Hot spring spa control panel instructions

How do I reset my hot tub control panel?

You can reset a hot tub control panel by switching it off, waiting for between 10 and 20 seconds and then switching it back on again. If the error signal continues on the control panel then you will need to consult your hot tub manual to see what the problem is.

How do you reset a hot spring portable spa?

  1. Move the remote closer to the spa.
  2. Press the Jets button on the dock unit; if it’s necessary to reset the panel, press and hold the touchscreen in any blank area until it turns black.

How do I unlock my hot tub control panel?

To unlock the panel, while holding down the “Temperature” button (or the “Up” button if you do not have the “Temperature” button), gently press and release the “Light” button twice.

How do you adjust the temperature on a hot springs spa?

To increase the set temperature of the spa water, press the TEMP plus (+) button. Each time the button is pressed, the set temperature display will increment by one degree. If the button is held down, the set temperature display will increase by one degree every half-second.

How do I know if my heating element is bad in my hot tub?

To test hot tub heating elements for integrity, use an ohm meter on its lowest setting. With the meter’s test leads, measure the resistance between the two element terminals. The acceptable resistance range for most heaters is between 9-12Ω (ohms), some may be as high as 20Ω.

You might be interested:  Palms place hotel and spa las vegas

How do I test my hot tub control panel?

Turn the power on and check if the hot tub heats up or starts to filter. The surest way to check if a control panel works is to use one you know is working and connect it to the circuit board.

Where is the reset button on a Hot Springs hot tub?

This may be due to the heater’s high limit thermostat being tripped. Disconnect the power source from the spa. Wait 30 seconds and reset the heater high limit. The reset button is located in the equipment compartment.

Where is the high limit switch on my hot tub?

A limit switch will be located in your heater enclosure, mostly in its lower left corner. It is usually white in color with a red button at the center. If your water is not heating up and you think the heater is the problem, one heater element that you need to check out will be the limit switch.

How do you unlock the Sundance spa control panel?

Press DISPLAY, MODE and (down) button within 3 seconds to unlock panel. HOLD Control Panel and remote panel are temporarily deactivated.

How do I unlock my Marquis spa control panel?

Panel Lock Press TEMP+ or TEMP- pad followed by QUIET SOAK pad to lock. Then press TEMP+ or TEMP- pad followed by QUIET SOAK pad to unlock.

What should I set my hot tub temperature?

The majority of hot tub users prefer a water temperature in the range of 100°F-102°F. 104°F is the standard maximum temperature, which some users also prefer. Always consult a physician before getting in the hot tub while pregnant.

You might be interested:  Hot springs spa review

How do I increase the temperature on my hot tub?

Adjust the temperature using the control panel.

Simply find the buttons that control the water’s temperature and turn it to 102 degrees. If at any point you had to remove the hot tubs cover, be sure to put it back on so that the hot tub won’t loose any more heat than is necessary.

Leave a Reply

Your email address will not be published. Required fields are marked *