SPA tips

Hot springs spa troubleshooting

Where is the reset button on a Hot Springs hot tub?

This may be due to the heater’s high limit thermostat being tripped. Disconnect the power source from the spa. Wait 30 seconds and reset the heater high limit. The reset button is located in the equipment compartment.

How do I reset my hot tub control panel?

You can reset a hot tub control panel by switching it off, waiting for between 10 and 20 seconds and then switching it back on again. If the error signal continues on the control panel then you will need to consult your hot tub manual to see what the problem is.

Why is my Hot Springs Spa not heating?

Why is my spa not heating? Make sure: The water is at a level which covers all of the jets as this affects the water flow through the heater. … If a Hot Spring Spa: Some heaters have a reset button, refer to owner’s manual for location or other tips.

Why is my hot tub light flashing?

It also provides a diagnostic function–a blinking power indicator indicates that the heater high limit has tripped, meaning that either the spa water is above its acceptable temperature range, or a malfunction has occurred within the spa (such as low circulation due to clogged filters).

Is it worth repairing a hot tub?

A well made hot tub should last around 10-15 years. If your hot tub is only 5 or 6 years old, it almost always makes sense to repair it as you should have at least another 5 years life out of it. On the other hand if your hot tub 15 or more years old it is likely living on borrowed time and should probably be replaced.

You might be interested:  Mandalay bay spa price

How do I know if my hot tub circulation pump is working?

One of the best things about a hot tub circulation pump is quiet operation; they make almost no noise. Gurgling, humming or grinding noises on a spa circulation pump are good indicators of a problem.

Why is my spa pump not working?

When your hot tub pump is dead…

Check that your power is on, the breaker or GFCI test button are not tripped, all valves are in the open position. Follow the circ pump plumbing, and look for any kinks in the hose. Pull out the cartridge filter to see if flow improves and the circulation pump is doing better.

How do I test my hot tub control panel?

Turn the power on and check if the hot tub heats up or starts to filter. The surest way to check if a control panel works is to use one you know is working and connect it to the circuit board.

Why is my Cleverspa not heating up?

It may be that your filter is dirty. A dirty filter will not efficiently allow water to be drawn through the internal heater, where it would be heated and pumped back into the hot tub. Check your filter is clean, if you are unsure watch our video.

How can I heat my hot tub faster?

You can heat a hot tub faster by turning on the jets, placing a cover over the tub, and using a more powerful heater. These are the easiest and most effective ways to increase your tub’s heating speed. It would be best if you didn’t fill a tub with hot water.

You might be interested:  Raise ph in spa

How do you test a spa temperature sensor?

Testing Spa Temperature Sensors

  1. Shut off all power to the spa at the breaker and spa pack.
  2. Set your Ohm meter to the 20K setting.
  3. Locate the wire ends and remove the plug from the board.
  4. Place your meter leads onto the green and red wire.
  5. Compare readings to Thermistor Resistance vs. Temperature Chart.

How do I reset the high limit switch on my hot tub?

The High Limit Switch Needs to Be Reset or Replaced

Or it might need a reset from time to time for no known or serious reason. Simply reset by pressing the big red button on your spa pack. The high limit switch may be housed in a thermowell.

Leave a Reply

Your email address will not be published. Required fields are marked *