SPA tips

Sundance spa trouble shooting

How do I reset my hot tub control panel?

You can reset a hot tub control panel by switching it off, waiting for between 10 and 20 seconds and then switching it back on again. If the error signal continues on the control panel then you will need to consult your hot tub manual to see what the problem is.

Why is my hot tub not working?

When jets start failing, the most likely case is that your hot tub pump is not working correctly. You will need to diagnose hot tub problems relating to the pump. Check your pump’s priming to make sure it is working properly. Open the access panel and the airlock valve close to the pump.

How do you unlock the Sundance spa control panel?

Press DISPLAY, MODE and (down) button within 3 seconds to unlock panel. HOLD Control Panel and remote panel are temporarily deactivated.

How do I fix error 6 on my spa?

What To Do When My Endless Spa has an Error 6 Code?

  1. Turn the spa OFF.
  2. Remove filters from the spa and give them a clean.
  3. Remove air locks by bleeding the barrel union on the pumps (You may have more than one pump – please check). To do this, turn the highest barrel union on the pumps anti-clockwise slowly until some water is released.

How do you fix LF error on a hot tub?

For the error messages of HFL, LF, Dr, or DRY. This means that there is a flow issue through your heater. Try and clean your filters. While cleaning your filter make sure there is no debris in your hot tub that will get sucked down into your pump.

You might be interested:  Hilton head marriott resort & spa hilton head island sc

How do I know if my heating element is bad in my hot tub?

To test hot tub heating elements for integrity, use an ohm meter on its lowest setting. With the meter’s test leads, measure the resistance between the two element terminals. The acceptable resistance range for most heaters is between 9-12Ω (ohms), some may be as high as 20Ω.

How do I test my hot tub control panel?

Turn the power on and check if the hot tub heats up or starts to filter. The surest way to check if a control panel works is to use one you know is working and connect it to the circuit board.

How do you reset a Balboa Spa Pack?

Remove the spa cover and allow water to cool. At 107¡F (approximately 41.7¡C), the spa should automatically reset. If spa does not reset, shut off the power to the spa. Standby Mode has been activated by pressing a button combination on the user panel.

Do hot tubs have a reset button?

A spa heater has a high-limit reset button. A spa or hot tub provides a form of personal relaxation known as hydrotherapy. … A spa heater may need to be reset if it has tripped or stopped working. Using the high-limit reset switch and checking all breakers and GFCI outlets can reactivate the spa’s heater.

How do you troubleshoot a hot tub pump?

Troubleshooting Your Hot Tub Pump

  1. Turn down the heat so it won’t keep trying to run.
  2. Open all the jets fully.
  3. Run the jets on high for about 15 seconds.
  4. Repeat the jet bursts three times, increasing the run time by 10–15 seconds each time.
  5. When air bubbles out of the jets, leave them on until the bubbling stops.
You might be interested:  Ballston -"ballston spa" -"ballston lake" -"saratoga"

How long does a Sundance hot tub last?

20 years

How do I unlock my hot tub control panel?

To unlock the panel, while holding down the “Temperature” button (or the “Up” button if you do not have the “Temperature” button), gently press and release the “Light” button twice.

Leave a Reply

Your email address will not be published. Required fields are marked *