Usefeul

Dimension one spa troubleshooting

How do I reset my hot tub control panel?

You can reset a hot tub control panel by switching it off, waiting for between 10 and 20 seconds and then switching it back on again. If the error signal continues on the control panel then you will need to consult your hot tub manual to see what the problem is.

What does low flow mean on hot tub?

There are a couple of common causes for flow errors in hot tubs; low water level, dirty filters, clogged circulation pumps, and bad flow sensors. … If the water gets too low and the spa’s filter well is not completely submerged it can cause air to be drawn into the system giving you a low flow error.

Why is my hot tub not working?

When jets start failing, the most likely case is that your hot tub pump is not working correctly. You will need to diagnose hot tub problems relating to the pump. Check your pump’s priming to make sure it is working properly. Open the access panel and the airlock valve close to the pump.

How do I know if my heating element is bad in my hot tub?

To test hot tub heating elements for integrity, use an ohm meter on its lowest setting. With the meter’s test leads, measure the resistance between the two element terminals. The acceptable resistance range for most heaters is between 9-12Ω (ohms), some may be as high as 20Ω.

How do I test my hot tub control panel?

Turn the power on and check if the hot tub heats up or starts to filter. The surest way to check if a control panel works is to use one you know is working and connect it to the circuit board.

You might be interested:  Mandarin oriental spa las vegas

How do you fix low flow in a hot tub?

Solution A

If the water level is not correct, top up the water level – switch off the power & remove the filters – after 20 minutes, switch the power back on & run the spa/jets without the filters to see if it clears the flow issue.

How do you unblock a spa jet?

The first thing you want to do is:

  1. Turn your system back on, but turn the heat down to as low as it will go. This step will keep the heater from kicking on during this process.
  2. Next, go around your hot tub and make sure all of the jets are completely open.

What does OH mean on hot tub display?

side pump overheating

Leave a Reply

Your email address will not be published. Required fields are marked *