Usefeul

Sundance spa reset button

How do I reset my hot tub control panel?

You can reset a hot tub control panel by switching it off, waiting for between 10 and 20 seconds and then switching it back on again. If the error signal continues on the control panel then you will need to consult your hot tub manual to see what the problem is.

Where is the reset button on a Hot Springs hot tub?

This may be due to the heater’s high limit thermostat being tripped. Disconnect the power source from the spa. Wait 30 seconds and reset the heater high limit. The reset button is located in the equipment compartment.

How do you reset the bulb on a Sundance spa?

blb error on Sundance Spa

  1. Ensure your spa is in ‘Standard’ Mode.
  2. Then, press the (CYCLE) button three times; The screen will display “U.” At this time the system is ready to accept your changes.
  3. Press the select button and it will read “ON”.
  4. Press the up or down temperature button until it reads “OFF”.

How do you reset a Balboa Spa Pack?

Remove the spa cover and allow water to cool. At 107¡F (approximately 41.7¡C), the spa should automatically reset. If spa does not reset, shut off the power to the spa. Standby Mode has been activated by pressing a button combination on the user panel.

Why is my spa not heating up?

Low flow in your spa or hot tub is most commonly associated with a dirty spa filter. If your spa heater won’t heat, remove and clean the filter(s) rule out a pressure or flow rate problem. Low water level, a clogged pump impeller, closed valves, clogged pipes or blocked spa drain covers can also cause flow issues.

You might be interested:  Best spa cover lift

How do I reset the high limit switch on my hot tub?

The High Limit Switch Needs to Be Reset or Replaced

Or it might need a reset from time to time for no known or serious reason. Simply reset by pressing the big red button on your spa pack. The high limit switch may be housed in a thermowell.

Is it worth repairing a hot tub?

A well made hot tub should last around 10-15 years. If your hot tub is only 5 or 6 years old, it almost always makes sense to repair it as you should have at least another 5 years life out of it. On the other hand if your hot tub 15 or more years old it is likely living on borrowed time and should probably be replaced.

How do you fix the error code on a hot tub?

DR or DRY Error Message

Like FLO issues, this can commonly be fixed by topping off your hot tub water level. DR or DRY will show up if there is little to no water travelling through your heater.28 мая 2018 г.

How do you troubleshoot a flow switch?

How to Troubleshoot Flow Switch Operation

  1. Turn the unit off and unplug it from the power source for 30 seconds. …
  2. Ensure the flow switch valve is open. …
  3. Look at the water level in the hot tub. …
  4. Clean out the filter. …
  5. Check the output pressure and input pressure of the spa’s jets and filter. …
  6. Confirm the LED indicator light under the pack cover is wired correctly.
You might be interested:  South point casino and spa

How do you fix LF error on a hot tub?

For the error messages of HFL, LF, Dr, or DRY. This means that there is a flow issue through your heater. Try and clean your filters. While cleaning your filter make sure there is no debris in your hot tub that will get sucked down into your pump.

Leave a Reply

Your email address will not be published. Required fields are marked *